Ichiba V2 Spacers Installation

Tuesday December 4, 2012

Ichiba spacers offer a simple way to stance out your OE or aftermarket wheels. The 2010 Subaru WRX you see featured on this blog post is our Subaru rep, Alex Skatkov. Alex recently installed a set of the “Version 2″ spacers with basic hand tools so we could showcase the simplicity behind the installation.

Ichiba Manufacturer Page – Ichiba Hubcentric Wheel Spacers

As you can see the Ichiba Version 2 wheel spacer has lengthened wheel studs built directly into the spacer along with an empty bolt pattern for your original studs to fit into. Clean off your hub build up with a scrub pad, slide the spacer directly on your hub, torque down with the included nuts, and put your wheel back on. Installation literally take only minutes.

Alex chose to go with the 17mm in the front and 20mm in the rear but we have many sizes available ranging from 5mm to 38mm. Check out our Ichiba Wheel Spacers – New Sizes blog post from about a month back to see some up close detailed photos of the spacers along with a full list of available sizes.

2 Responses to “Ichiba V2 Spacers Installation”

Leave a Reply

Please leave these two fields as-is: